CS18B - Concurrent Session 18B: Liquefaction Assessment in Gravels using Vs and DPT Blow count from Case Histories
Tuesday, September 19, 2023
2:00 PM – 2:30 PM PDT
Location: Smoketree A-E
Gravelly soils have liquefied at multiple sites in at least 27 earthquakes over the past 130 years. These gravels typically contain more than 25% sand which lowers the permeability and makes them susceptible to liquefaction. Developing a reliable, cost-effective liquefaction triggering procedure for gravelly soils has been a challenge for geotechnical engineers. Typical SPT- or CPT-based correlations can be affected by large-size gravel particles and can lead to erroneous results. To deal with these problems, we have developed liquefaction triggering curves for gravelly soils based on (1) shear wave velocity (Vs) and (2) a large diameter cone penetrometer. With a cone diameter of 74 mm the Chinese Dynamic Cone Penetration Test (DPT) is superior to smaller penetrometers and can be economically performed with conventional drilling equipment. Using logistic regression analysis, the DPT has been directly correlated to liquefaction resistance at sites where gravels did and did not liquefy in past earthquakes. Probabilistic liquefaction resistance curves were developed based on 137 data points from 10 different earthquakes in seven countries. Using a similar data set, probabilistic liquefaction triggering curves were also developed based on Vs measurements in gravelly soils. The Vs-based liquefaction triggering curves for gravels shift to the right relative to similar curves based on sands. New magnitude scaling factor (MSF) curves have also been developed specifically for gravel liquefaction which were reasonably consistent with previous curves for sand. Comparative analyses for sites at Centreport in Wellington indicate that liquefaction assessment from the DPT was very consistent with those from the cone penetration test (CPT) for the loose gravelly soils involved.